EngineeringDrawing

Search This Blog

Make a complete set of detail drawings for a V-block Clamp shown

on September 26, 2024

Get link
Facebook
X
Pinterest
Email
Other Apps

Make a complete set of detail drawings for a V-block Clamp shown

In this Question, we separate the different components of V-block clamp and draw them separately as shown in figure below:

Detail Drawing

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

A model of steps has 3 steps of 15 mm tread and rise 10 mm. The steps measure 60 mm wide. The vertical edge of bottom steps, which is nearer to the picture plane, is 25 mm behind and the width of steps recede to the left at an angle of 300 to PP. The station point is 100 mm in front of PP and 60 mm above the ground plane and 30 mm to the right of the vertical edge, which is nearest to PP. Draw the perspective view of the model

A model of steps has 3 steps of 15 mm tread and rise 10 mm. The steps measure 60 mm wide. The vertical edge of bottom steps, which is nearer to the picture plane, is 25 mm behind and the width of steps recede to the left at an angle of 300 to PP. The station point is 100 mm in front of PP and 60 mm above the ground plane and 30 mm to the right of the vertical edge, which is nearest to PP. Draw the perspective view of the model.

Draw the front view with section and top view of the assembly with the detail drawing shown

Draw the front view with section and side view of the bearing.

Figure shows the details of a bearing. Draw the front view with section and side view of the assembly.

Make a complete set of detail drawings for a V-block Clamp shown

Comments

Post a Comment